Many of us have no idea how plumbing works. Knowing a few simple tips and tricks can help you keep your money in your hands and not that of a plumber. Sometimes, it is necessary to call up a plumber, but by following a few words of advice, you can take preemptive action and stop a problem before it starts.
If your pipes are prone to freezing, let the water trickle continuously in at least one faucet during weather that is below freezing. This will minimize the chances that the pipes will freeze and leave you without water. If water is continually running through the pipes and trickling out of a faucet, the pipes are less likely to freeze. During the winter, preventing frozen pipes when you live in a small dwelling can be something good to know. Frozen pipes will not only stop your flow of water but can crack and damage pipes. You can prepare your plumbing for the winter by running a little water out of every faucet during the coldest parts of the day and avoid this.
There are many ways to unclog a drain. You can try plunging it at first. If that doesn’t work try using a chemical agent from the store. Before you go and spend money at the store though, if you have baking soda and some vinegar handy, you can mix those together and pour them in the drain and try to plunge that but if all else fails they have stronger remedies at your local hardware store.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
DIY plumbing jobs will require that you understand how to solder copper for the lines for the water supply. You can practice this skill so that you will be able to run your lines without worrying about it leaking. Search online for video tutorials that can help you get a handle on how to go about soldering.
You can remove unsightly mineral buildup from your shower head by soaking it in vinegar overnight. This loosens the deposits, and in the morning you only need to wipe off the residue with a rag. If your shower head is high up an not removable, place vinegar in a plastic bag, slip the bag over the shower head and hold in place with a twist tie.
Hopefully this article helped you learn a little bit more about your plumbing and how to stop issues before they start. By learning and knowing, like was discussed in this article, you can be sure to save a few dollars every year. Plumbing disasters can cost a lot of money, so use this advice well!